全部分类

Operation process and maintenance of CCD punching machine

Published:

2022-11-23 15:16

Operation process of CCD punching machine

 

1. Check whether the power/air switch is normal before operation;

2. Unlock the red emergency switch and press the green key to start the machine;

3. When the main operation interface with cross bull's-eye appears on the touch screen, press "Start" to enter the automatic state;

4. Move the complete contour of the target circle (product) to the screen (the machine can quickly identify and automatically punch);

5. When the identification ability declines/cannot be identified/punching eccentricity occurs, please report to the team/group leader or relevant technicians for debugging;

6. The debugging process is mainly to set the "binarization" parameters. The binarization values required by different materials and light sources are different. Other parameters remain unchanged, and the punching of all products of the company is | 2.0mm;

7. Press "Setting" in the main operation interface of power on, and then press "Binary". In the "Image Binary" interface, touch the lower left corner of the screen to switch the light source, which are: upper light source, lower purple light, lower infrared light; The three-way light source can also be used at the same time. The use principle shall be subject to the best image definition. Tap the up and down arrows to adjust the definition of the binary image, move the target in the screen, and adjust it to the clearest position of the image to ensure that the device can correctly identify the image;

8. After work, press the red emergency switch directly and turn off the air source switch.

Maintenance of CCD punching machine

1. Clean the machine once per shift to keep the machine table clean and free of debris;

2. Add lubricating oil to the rotating part of the machine every shift to ensure that the machine rotates normally without rust;

3. Do not touch or scratch the reflective lens;

4. Do not lift or press the white worktable when moving the equipment;

5. The equipment shall not be placed outside the strong light, otherwise the binary image will be affected and punching deviation will be caused.

More technical information: http://www.szvstar.cn

Recommended News